Hardware Design
Third-party hardware development that helps drive innovation — from component research and electrical design through PCB layout, bring-up, and design-failure remediation across consumer, automotive, IoT, and industrial platforms.
Request a QuoteFrom Concept Through Silicon to Production
Engineers and product designers at Novus Labs bring innovation and deep technical expertise to every project that relies on complex hardware. Whether you need help selecting components, optimizing a board layout, debugging a tricky high-speed signal, or evaluating a legacy product seeing field failures, our hardware team works alongside yours to ship the right design.
Our experience spans the full design lifecycle — strategic component research, fine-pitch BGA layout, EMI/EMC mitigation, high-speed digital and analog/mixed-signal design, and adaptable embedded designs targeting SOC, ASIC, and FPGA devices. We have supported component selection and design-review programs for Microsoft, Peloton, Williams Sonoma, Logitech, and other industry leaders.
- Strategic component research and supplier evaluation
- Fine-pitch BGA layout, EMI/EMC, and high-speed digital design
- Analog and mixed-signal circuit design
- Embedded design for SOC, ASIC, and FPGA targets
- Design review and field-failure remediation for legacy products
Where We Deliver
Three focused service lines covering the hardware design lifecycle — from up-front component research through electrical design and embedded silicon enablement.
- Strategic research into emerging technologies
- Component characterization & supplier evaluation
- Antenna subsystem routing & selection
- Schematic and layout design review
- Field-failure root-cause analysis
- Fine-pitch BGA layout
- High-speed digital & SerDes design
- Analog and mixed-signal circuits
- EMI / EMC mitigation
- Manufacturability optimization (DfM)
- SOC, ASIC, and FPGA targets
- Resource & power-constrained tailoring
- Board bring-up and board support
- Driver & low-level firmware enablement
- Long-term sustaining engineering
Deep Coverage Across the Hardware Stack
From physical layout to embedded silicon, our hardware engineers cover the disciplines that determine whether a connected product works reliably in the field.
- Fine-pitch BGA
- Multi-layer stack-up
- Manufacturability (DfM)
- High-speed digital
- DDR & SerDes
- Mixed-signal isolation
- PDN design
- Decoupling strategies
- Switching regulator layout
- Pre-compliance scanning
- Shielding & emissions layout
- Filtering & grounding
- SOC integration
- ASIC partition support
- FPGA design & verification
- Antenna selection & routing
- RF front-end design
- Wireless co-existence
- Bring-up boards & breakouts
- Mechanical & enclosure prototypes
- Design-print-test iteration
- Schematic & layout review
- Component-selection feedback
- Field-failure remediation
Ready to Bring Your Hardware Design to Life?
Talk to a Novus engineer about component selection, PCB layout, embedded silicon, or design review.